centerline and ucl lcl for the x bar and s charts

In the production of a precision mechanical component, a critical dimension is measured every hour, and at that time we take a sample of n=5 units. From 30 initial samples we find that x-bar = 200 and S-bar = 0.5,
What are the centerline and UCL, LCL for the x-bar and S charts?
Observing the charts we conclude that the process is in a state of statistical control. If the part specifications are 199 ± 2, what are:
Two remedies to the low Cpk have been suggested:
– Center the process at the target – i.e. X-bar-bar = 199
– Reduce the standard deviation to half of its original value through better tooling maintenance.
Which will achieve a higher Cpk?
Shfting xBarbar, Sifting S, they will both achieve the same Cpk, or Neither change will improve Cpk

“Looking for a Similar Assignment? Get Expert Help at an Amazing Discount!”


"Is this question part of your assignment? We Can Help!"

Essay Writing Service